/* * Copyright (c) 2021 hpmicro * * SPDX-License-Identifier: BSD-3-Clause * */ #ifndef _RTT_BOARD_H #define _RTT_BOARD_H #include "hpm_common.h" #include "hpm_soc.h" /* gpio section */ #define APP_LED0_GPIO_CTRL HPM_GPIO0 #define APP_LED0_GPIO_INDEX GPIO_DI_GPIOB #define APP_LED0_GPIO_PIN 11 #define APP_LED1_GPIO_CTRL HPM_GPIO0 #define APP_LED1_GPIO_INDEX GPIO_DI_GPIOB #define APP_LED1_GPIO_PIN 12 #define APP_LED2_GPIO_CTRL HPM_GPIO0 #define APP_LED2_GPIO_INDEX GPIO_DI_GPIOB #define APP_LED2_GPIO_PIN 13 #define APP_LED_ON (0) #define APP_LED_OFF (1) /* mchtimer section */ #define BOARD_MCHTMR_FREQ_IN_HZ (24000000UL) /* SPI WIFI section */ #define RW007_RST_PIN (IOC_PAD_PE02) #define RW007_INT_BUSY_PIN (IOC_PAD_PE01) #define RW007_CS_PIN (IOC_PAD_PE03) #define RW007_CS_GPIO (HPM_GPIO0) #define RW007_SPI_BUS_NAME "spi1" /* CAN section */ #define BOARD_CAN_NAME "can0" #define BOARD_CAN_HWFILTER_INDEX (0U) /* UART section */ #define BOARD_UART_NAME "uart13" #define BOARD_UART_RX_BUFFER_SIZE BSP_UART13_RX_BUFSIZE /* eeprom section */ #define BOARD_EEPROM_I2C_NAME "i2c0" #define BOARD_SD_NAME "sd1" /* audio section */ #define BOARD_AUDIO_CODEC_I2C_NAME "i2c0" #define BOARD_AUDIO_CODEC_I2S_NAME "i2s0" /* PWM section */ #define BOARD_PWM_NAME "pwm2" #define BOARD_PWM_CHANNEL (0) #define IRQn_PendSV IRQn_DEBUG_0 /*************************************************************** * * RT-Thread related definitions * **************************************************************/ extern unsigned int __heap_start__; extern unsigned int __heap_end__; #define RT_HW_HEAP_BEGIN ((void*)&__heap_start__) #define RT_HW_HEAP_END ((void*)&__heap_end__) typedef struct { uint16_t vdd; uint8_t bus_width; uint8_t drive_strength; }sdxc_io_cfg_t; #if defined(__cplusplus) extern "C" { #endif /* __cplusplus */ void app_init_led_pins(void); void app_led_write(uint32_t index, bool state); void app_init_usb_pins(void); #if defined(__cplusplus) } #endif /* __cplusplus */ #endif /* _RTT_BOARD_H */